YASKAWA SVC User Manual page 513

STEP 5: Set the Required Setting Parameters
1.
Set the required parameters in the setting column on the Setting/Monitor Parameter Tab
Page.
*1
*2
*1.
This is the data that is output continually during execution of the Inverter Drive Control command.
*2.
This data is enabled when the Inverter Drive Control command is being executed and the Output Data
Option Selection parameter (OW0C) is set to 1 (enable), or when the Inverter I/O Control sub-
command is being executed and the Auxiliary Output Data Option Selection parameter (OW0E) is
set to 1 (enable).
Note: The Inverter I/O Control subcommand is valid only for MECHATROLINK-III 64-byte Mode.
This concludes the procedure.
Monitoring Method
Information
You can monitor a parameter by double-clicking the monitor data column cell to monitor on
the Monitor Parameter Tab Page.
*1
*2
*1.
This is the data that is input continually during execution of the Inverter Drive Control com-
mand.
*2.
This data is enabled when the Inverter Drive Control command is being executed and the Input
Data Option Selection parameter (OW0D) is set to 1 (enable), or when the Inverter I/O
Control subcommand is being executed and the Auxiliary Input Data Option Selection parame-
ter (OW0F) is set to 1 (enable).
Note: The Inverter I/O Control subcommand is valid only for MECHATROLINK-III 64-byte Mode.
10.2 Setup Procedure
10.2.2 Inverter Settings
10-11
10