Table of Contents
Advertisement
• Saving in M Registers from a Ladder Program
This method saves the value of the zero point position offset in the machine coordinate system
in M registers when the zero point is set. When the power supply for the MP3000 is turned ON
again, the value of the M registers is stored in the OL
Position Offset in Machine Coordinate System).
In a ladder program, program instructions that automatically execute the following sequence.
Programming Examples
The following diagram shows an example of the ladder programming to use to store the offset-
ting of axis 1 of circuit number 1.
In the ladder program for an actual application, change the register address for each axis.
The ladder programming that is shown here is used to perform the following processing.
• After the origin is set, the program subtracts the value of the IL
(Machine Coordinate System Calculated Position (CPOS)) from the OL
eter (Zero Point Position Offset in Machine Coordinate System), and stores that value in
OL
48. This value is also saved in M registers at the same time.
• After the origin is set, the value that is saved in the M registers is stored in OL
Save the value of OL
registers only when the value of OL
ing that constantly saves the value of OL
Important
tions.
Infinite-length Operation
Infinite-length axis positioning automatically resets the machine position, the program position
(absolute value in the program coordinate system), and the current position at regular intervals
according to the value set in fixed parameter No. 10 (Infinite-length Axis Reset Position (POS-
MAX)). With this function, the system can operate the axis as an infinite-length axis that per-
forms repeated positioning in the same direction.
This concept is shown below.
5.2.6 Position Management Method for Each Machine Operation Type
Signal that turns ON only when setting the machine coordinate sys-
tem origin (The diagram below shows an example of external signal.
The register address here has no special meaning.)
Execute this every scan in a high-speed drawing.
48 (Zero Point Position Offset in Machine Coordinate System) to the M
48 is updated, such as when the origin is set. Process-
48 to the M registers may cause position varia-
POSMAX
0
5.2 Absolute Encoders
48 setting parameter (Zero Point
10 monitor parameter
48 setting param-
48.
5
5-31
Advertisement
Table of Contents
