YASKAWA SVC User Manual page 440

7.1 Module Configuration Settings
7.1.1 Settings for Motion Control Function Modules
No.

Comment
*
Set I/O registers so that the same registers are not used by more than one Function Module.
Important
 Status Display Contents
The items displayed in the Status Column are listed below.
 Status of the CPU, Communications Function Modules, Motion Control Function
Modules, and Option Modules
The following will be displayed as the status of the CPU, Communications Function Modules,
Motion Control Function Modules, and Option Modules.
-----
Empty
Driving
Failure
×
Initializing
Driving Stop
Duplicate Address
 Transmission Status for the SVC Function Module
The following status is displayed for the SVC Function Module.
No Alarm
High Speed Scan Trans-
mission Error
Low Speed Scan Trans-
mission Error
Duplicate Address
7-4
Item
Displays the user comment.
1. Always save all settings to the flash memory after changing them.
2. When changing the settings, be careful not to set register addresses that overlap with other
Function Modules.
3. Set I/O start and end registers even if an I/O Module is not connected to the MECHATROLINK
network.
Display
Undefined.
Defined but not connected.
Operating normally.
Error detected.
The connected Module has a different name from the Module defined on the
Module Configuration Definition Tab Page.
The Module is connected but the Module configuration is not defined.
The CPU is stopped (The user programs are stopped).
The same station address is used for more than one connected MECHA-
TROLINK-III slave device.
Display
Transmission is normal.
A transmission error has occurred. (The high-speed scan is set for the I/O scan
for the station.)
A transmission error has occurred. (The low-speed scan is set for the I/O scan for
the station.)
The same station address is set for more than one slave device.
Display/Setting Item
Description
Description
Continued from previous page.
Setting Range/Settings
You can enter up to 16
characters for a Function
Module. You can enter up
to 32 characters for a
MECHATROLINK slave.
Changing
Possible