Table of Contents
Advertisement
7.2 MECHATROLINK Communications Settings
7.2.2 MECHATROLINK Detail Definition Dialog Box Details
Link Assignment Tab Page
The Link Assignment Tab Page displays the assignment settings for all slave devices that were
detected during self-configuration (MECHATROLINK-III-connected devices, such as SERVO-
PACKs or distributed I/O).
No.
11
12
13
Refer to the following section for details on each item.
Item Details
This section provides details on the items that are displayed on the Link Assignment Tab Page.
Important
ST #
This is the station number.
The number of rows that is displayed corresponds to the number of slave stations that is set on
the Transmission Parameters Tab Page.
This number is automatically assigned.
ADR
Set the station address of the slave station.
7-10
Item
ST #
ADR
ExADR
VENDOR
DEVICE
PROFILE
BYTE
INPUT
OUTPUT
D
SIZE
SCAN
Comment
Item Details on page 7-10
Always save all settings to the flash memory after you change them.
11 11
11 11
12 12
Displays the station number.
Sets the station address of the slave station.
Sets the individual extended addresses when multi-station modules
(multi-slaves) are grouped together as a single node.
Sets the vendor name of the device.
Sets the slave model.
Sets the profile to use.
Sets the number of transmission bytes.
Sets the first register address of the input area.
Sets the first register address of the output area.
Enables or disables the I/O registers.
Sets the input or output size in words.
Sets the scan in which the input or output is performed.
Enter a comment of up to 32 characters if required.
13 13
Description
Advertisement
Table of Contents
