YASKAWA SVC User Manual page 176

 Setting Parameters
Register Address
Zero Point Return

OW 3C
Method
Speed Reference Set-

OL 10
ting

OL 3E Approach Speed
Zero Point Return

OL 42
Travel Distance
 HOME LS + C Pulse (OW3C = 14)
 Operation after Origin Return Starts
1.
Travel is started at the approach speed in the direction that is specified by the sign of
the approach speed.
2.
When the rising edge of the HOME signal is detected, the speed will be reduced to
creep speed.
3.
Positioning is performed at the positioning speed when the first phase-C pulse is
detected after the falling edge of the HOME signal.
4.
When the positioning operation has been completed, the machine coordinate system is
established with the position at the end of the positioning operation as the origin.
• Normal Execution
Approach Speed
(OL
Start
HOME signal
Phase-C pulse
*3
N-OT
Name
13: P-OT only
Set the positioning speed to use after the P-OT signal is
detected. The sign is ignored.
The travel direction depends on the sign of the Zero Point
Return Travel Distance parameter.
Set the speed at which to begin the origin return operation.
Add a sign to this setting so that the travel direction will be pos-
itive.
Set the travel distance after detecting the P-OT signal.
The travel direction depends on the sign.
3E)
Speed Reference Setting
Creep Speed
(OL 40)
*1
4.2 Motion Command Details
4.2.3 ZRET (Zero Point Return)
Setting Details
(OL 10)
Zero Point Return
Travel Distance
(OL 42)
Origin
*2
P-OT
4
4-33