YASKAWA SVC User Manual page 45

Turn ON the power supply to the MECHATROLINK-III slave devices first or at the same time as
the MP3000. If turning ON the power supply to the MP3000 first is unavoidable, reset the net-
work after you turn ON the power supply to the MECHATROLINK slave devices.
Otherwise, MECHATROLINK communications may not be performed correctly.
Important
 Using the MP3300
The following figure shows a system configuration example that uses the SVC.
RLYOUT
connector cable
24-VDC power supply,
AC power supply, or
status monitoring device
Power cable
24-VDC power supply
or AC power supply
*
This manual primarily describes this area.
Note: 1. Refer to the following manual for information on cables, connectors, and applicable SERVOPACKs.
MP3000 Series MP3300 Product Manual (Manual No.: SIEP C880725 21)
2. When you connect a SERVOPACK through MECHATROLINK communications, connect the wiring for input
signals, such as overtravel, the zero point return deceleration limit switch, and external latches, to the SER-
VOPACK. Refer to the relevant SERVOPACK manual for details on the connections.
Turn ON the power supply to the MECHATROLINK-III slave devices first or at the same time as
the MP3000. If turning ON the power supply to the MP3000 first is unavoidable, reset the net-
work after you turn ON the power supply to the MECHATROLINK slave devices.
Otherwise, MECHATROLINK communications may not be performed correctly.
Important
Host PLC
Ethernet communications cable
MP3300
Battery
Front cover for
unused slot
MECHATROLINK-III
SERVOPACK with MECHATROLINK-III
Communications References
Servomotor Servomotor Servomotor
Up to 21 stations, including I/O (Up to 16 stations can be Servos.)
2.3 System Configuration Example
*
MPE720 Integrated
Engineering
Tool Version 7
PC
HUB
MECHATROLINK-III Cable
I/O Module with
MECHATROLINK-III
Communications
I/O
2
2-13