Common Service Commands - Alcatel-Lucent 7210 SAS M Service Manual

Common Service Commands

Common Service Commands
SAP syntax
sap
Syntax [no] sap sap-id
This command specifies the physical port identifier portion of the SAP definition.
Description
sap-id — Specifies the physical port identifier portion of the SAP definition.
Parameters
The sap-id can be configured in one of the following formats:
Type
port-id
slot/mda/port[.channel]
null [port-id | lag-id]
dot1q [port-id | lag-id]:qtag1
qinq [port-id | lag-id]:qtag1.qtag2
The values depends on the encapsulation type configured for the interface. The following table
describes the allowed values for the port and encapsulation types.
Port Type Encap-Type
Ethernet Null
Ethernet Dot1q
Ethernet QinQ
Page 940
Syntax
Allowed Values
0
0 — 4094
qtag1: 0 — 4094
qtag2: 0 — 4094
1/1/5
port-id: 1/1/3
lag-id: lag-3
port-id:qtag1: 1/1/3:100
lag-id:qtag1:lag-3:102
cp.conn-prof-id: 1/2/1:cp.2
port-id:qtag1.qtag2: 1/1/3:100.10
lag-id:qtag1.qtag2: lag-10:
Comments
The SAP is identified by the port.
The SAP is identified by the 802.1Q tag on the port.
Note that a 0 qtag1 value also accepts untagged packets
on the dot1q port.
The SAP is identified by two 802.1Q tags on the port.
Note that a 0 qtag1 value also accepts untagged packets
on the Dot1q port.
7210 SAS M Services Guide
Example