Alcatel-Lucent 7210 SAS M Service Manual page 112

ETH-CFM Configuration Commands
client-meg-level
Syntax client-meg-level [[level [level ...]]
no client-meg-level
Context config>port>ethernet>eth-cfm>mep>ais-enable
config>lag>eth-cfm> mep>ais-enable
This command configures the client maintenance entity group (MEG) level(s) to use for AIS message
Description
generation. Up to 7 levels can be provisioned with the restriction that the client MEG level must be
higher than the local MEG level. Only the lowest client MEG level will be used for facility MEPs.
The no form of the command reverts to the default values.
level — Specifies the client MEG level.
Parameters
interval
Syntax interval {1 | 60}
no interval
Context config>port>ethernet>eth-cfm>mep>ais-enable
config>lag>eth-cfm> mep>ais-enable
This command specifies the transmission interval of AIS messages in seconds.
Description
The no form of the command reverts to the default values.
1 | 60 — The transmission interval of AIS messages in seconds.
Parameters
priority
Syntax priority priority-value
no priority
Context config>port>ethernet>eth-cfm>mep>ais-enable
config>lag>eth-cfm> mep>ais-enable
This command specifies the priority of the AIS messages generated by the node.
Description
The no form of the command reverts to the default values.
priority-value — Specify the priority value of the AIS messages originated by the node.
Parameters
Page 112
1 — 7
Values
1
Default
1
Default
0 — 7
Values
7
Default
7210 SAS M Services Guide