Alcatel-Lucent 7210 SAS M Service Manual page 734

Show, Clear, Debug Commands
Page 734
Label
Admin State
Oper State
Hello Time
Hello Msg Len
Max Drop Count
Hold Down Time
SDP Delivery Mech-
anism
Max Drop Count
Number of SDPs
Service Access Points
Service Id
Port Id
Description
Admin State
Oper State
Last Changed
Admin MTU
Oper MTU
Ingress qos-pol-
icy
Egress qos-policy
Specifies the operating status of the keepalive protocol.
The current status of the keepalive protocol.
Specifies how often the SDP echo request messages are transmitted on
this SDP.
Specifies the length of the SDP echo request messages transmitted on
this SDP.
Specifies the maximum number of consecutive SDP Echo Request
messages that can be unacknowledged before the keepalive protocol
reports a fault.
Specifies the amount of time to wait before the keepalive operating sta-
tus is eligible to enter the alive state.
When the SDP type is MPLS, a list of LSPs used to reach the far-end
router displays. All the LSPs in the list must terminate at the IP address
specified in the far end field.
Specifies the maximum number of consecutive SDP Echo Request
messages that can be unacknowledged before the keepalive protocol
reports a fault.
The total number SDPs applied to this service ID.
The service identifier.
The ID of the access port where this SAP is defined.
Generic information about the SAP.
The desired state of the SAP.
The operating state of the SAP.
The date and time of the last change.
The desired largest service frame size (in octets) that can be transmit-
ted through this SDP to the far-end router, without requiring the packet
to be fragmented.
The actual largest service frame size (in octets) that can be transmitted
through this SDP to the far-end router, without requiring the packet to
be fragmented.
The SAP ingress QoS policy ID.
The SAP egress QoS policy ID. This command is applicable only to
7210 SAS X.
Description
7210-SAS M Services Guide