Alcatel-Lucent 7210 SAS M Service Manual page 840

Show, Clear, Debug Commands
sdp
Note : SDP commands are not supported by 7210 SAS-M devices configured in Access uplink mode.
sdp [sdp-id | far-end ip-addr] [detail]
Syntax
Context show>service>id
This command displays information for the SDPs associated with the service.
Description
If no optional parameters are specified, a summary of all associated SDPs is displayed.
sdp-id — Displays only information for the specified SDP ID.
Parameters
far-end ip-addr — Displays only SDPs matching the specified far-end IP address.
detail — Displays detailed SDP information.
Show Service-ID SDP — The following table describes show service-id SDP output fields:
Output
Page 840
All SDPs.
Default
1 — 17407
Values
SDPs with any far-end IP address.
Default
Label
Sdp Id
Type
Split Horizon
Group
VC Type
VC Tag
I. Lbl
Admin Path MTU
Oper Path MTU
Far End
Delivery
Admin State
Oper State
The SDP identifier.
Indicates whether the SDP is a spoke or a mesh.
Name of the split horizon group that the SDP belongs to.
The VC type, ether, vlan, or vpls.
The explicit dot1Q value used when encapsulating to the SDP far end.
The VC label used by the far-end device to send packets to this device
in this service by the SDP.
The operating path MTU of the SDP is equal to the admin path MTU
(when one is set) or the dynamically computed tunnel MTU, when no
admin path MTU is set (the default case).
The actual largest service frame size (in octets) that can be transmitted
through this SDP to the far-end router, without requiring the packet to
be fragmented.
Specifies the IP address of the remote end of the GRE or MPLS tunnel
defined by this SDP.
Specifies the type of delivery used by the SDP: GRE or MPLS.
The administrative state of this SDP.
The current state of this SDP.
Description
7210 SAS M Services Guide