Alcatel-Lucent 7210 SAS M Service Manual page 833

7210 SAS M Services Guide
Label
Encap
Ethertype
Admin State
Oper State
Flags
Last Status Change
Last Mgmt Change
Admin MTU
Oper MTU
Ingress qos-pol-
icy
Egress qos-policy
Ingress Filter-Id
Egress Filter-Id
Acct. Pol
Collect Stats
LLF Admin State
LLF Oper State
Loopback Mode
Loopback Src Addr
Loopback Dst Addr
No-svc-port used
Description (Continued)
The encapsulation type of the SAP.
Specifies an Ethernet type II Ethertype value.
The administrative state of the SAP.
The operating state of the SAP.
Specifies the conditions that affect the operating status of this SAP.
Display output includes: ServiceAdminDown, SapAdminDown,
InterfaceAdminDown, PortOperDown, PortMTUTooSmall,
L2OperDown, SapEgressQoSMismatch,RelearnLimitExceeded,
RxProtSrcMac, ParentIfAdminDown, NoSapIpipeCeIpAddr,
TodResourceUnavail, TodMssResourceUnavail, SapParamMis-
match, ServiceMTUTooSmall, SapIngressNamedPoolMismatch,
SapEgressNamedPoolMismatch, NoSapEpipeRingNode.
The time of the most recent operating status change to this SAP.
The time of the most recent management-initiated change to this SAP.
The desired largest service frame size (in octets) that can be transmit-
ted through the port to the far-end router, without requiring the packet
to be fragmented.
The actual largest service frame size (in octets) that can be transmitted
through the port to the far-end router, without requiring the packet to
be fragmented.
The ingress QoS policy ID assigned to the SAP.
The egress QoS policy ID assigned to the SAP.
The ingress filter policy ID assigned to the SAP.
The egress filter policy ID assigned to the SAP.
The accounting policy ID assigned to the SAP.
Specifies whether collect stats is enabled.
Displays the Link Loss Forwarding administrative state.
Displays the Link Loss Forwarding operational state.
Displays the Ethernet port loop back mode
Displays the configured loopback source address
Displays the configured loopback destination address
Displays the port ID of the port on which no service is configured.
This port is used for the port loop back with MAC swap functionality.
VLL Show Commands
Page 833