Alcatel-Lucent 7210 SAS M Service Manual page 544

IES Interface Commands
By default, generation of ICMP destination unreachable messages is enabled at a maximum rate of 10
per 60 second time interval.
The no form of this command disables the generation of icmp destination unreachable messages on
the router interface.
Default
unreachables 100 10
number — The maximum number of ICMP unreachable messages to send. This parameter must be
Parameters
seconds — The time frame in seconds used to limit the number of ICMP unreachable messages that
hash-label
Syntax [no] hash-label
Context config>service>ies>if>spoke-sdp
This command enables the use of the hash label on a VLL, VPLS, or VPRN service bound to LDP or
Description
RSVP SDP as well as to a VPRN service using the autobind mode with the with the ldp, rsvp-te, or
mpls options. This feature is not supported on a service bound to a GRE SDP or for a VPRN service
using the autobind mode with the gre option..
When this feature is enabled, the ingress data path is modified such that the result of the hash on the
packet header is communicated to the egress data path for use as the value of the label field of the
hash label. The egress data path appends the hash label at the bottom of the stack (BoS) and sets the
S-bit to 1 to indicate that.
In order to allow for applications whereby the egress LER infers the presence of the hash label
implicitly from the value of the label, the Most Significant Bit (MSB) of the result of the hash is set
before copying into the hash label. This means that the value of the hash label will always be in the
range [524,288 — 1,048,575] and will not overlap with the signaled/static LSP and signaled/static
service label ranges. This also guarantees that the hash label will not match a value in the reserved
label range.
The (unmodified) result of the hash continues to be used for the purpose of ECMP and LAG spraying
of packets locally on the ingress LER. Note however that for VLL services, the result of the hash is
overwritten and the ECMP and LAG spraying will be based on service-id when ingress SAP shared
queuing is not enabled. However, the hash label will still reflect the result of the hash such that an
LSR can use it to perform fine grained load balancing of VLL pseudowire packets.
Packets that are generated in CPM and forwarded labeled within the context of a service (for
example, OAM packets) must also include a hash label at the BoS and set the S-bit accordingly.
The TTL of the hash label is set to a value of 1.
The no form of this command disables the use of the hash label.
no hash-label
Default
Page 544
specified with the seconds parameter.
10 — 1000
Values
can be issued.
1 — 60
Values
7210-SAS M Services Guide