Alcatel-Lucent 7210 SAS M Service Manual page 867

sap-using
Syntax sap-using interface [ip-address | ip-int-name]
sap-using [ingress | egress] filter filter-id
sap-using [sap sap-id]
sap-using [ingress] qos-policy qos-policy-id
Context show>service
This command displays SAP information.
Description
If no optional parameters are specified, the command displays a summary of all defined SAPs.
The optional parameters restrict output to only SAPs matching the specified properties.
ingress — Specifies matching an ingress policy.
Parameters
egress — Specifies matching an egress policy.
filter filter-id — The ingress or egress filter policy ID for which to display matching SAPs.
sap-id — Specifies the physical port identifier portion of the SAP definition. See
Show Service SAP — The following table describes show service SAP output fields:
Output
i
Sample Output
*A:ALU_SIM2>config>service>vpls# show service sap-using
===============================================================================
Service Access Points
===============================================================================
PortId
-------------------------------------------------------------------------
1/1/1:10
1/1/3:500.*
7210 SAS M Services Guide
1 — 65535
Values
Command Descriptions on page 939
Label
Port ID
Svc ID
I.QoS
I.MAC/IP
Egr. Fltr
A.Pol
Adm
Opr
for command syntax.
The ID of the access port where the SAP is defined.
The service identifier.
The SAP ingress QoS policy number specified on the ingress SAP.
The MAC or IP filter policy ID applied to the ingress SAP.
The filter policy ID applied to the egress SAP.
The accounting policy ID assigned to the SAP.
The administrative state of the SAP.
The actual state of the SAP.
SvcId Ing.
QoS
1 1
1 1
VPLS Show Commands
Common CLI
Description
Ing. Egr. Adm
Fltr Fltr
none 1none Up
none 1none Up
Opr
Up
Up
Page 867