Show, Clear, Debug Commands
===============================================================================
*A:MTU-7210#
*A:MTU-T2#
===============================================================================
IGMP Snooping Proxy-reporting DB for service 100
===============================================================================
-------------------------------------------------------------------------------
IGMP Group 227.7.7.7
-------------------------------------------------------------------------------
Up Time : 0d 00:05:43
-------------------------------------------------------------------------------
IGMP Group 227.7.7.8
-------------------------------------------------------------------------------
Up Time : 0d 00:05:43
-------------------------------------------------------------------------------
IGMP Group 228.8.8.8
-------------------------------------------------------------------------------
Up Time : 0d 00:03:55
-------------------------------------------------------------------------------
Number of groups: 3
===============================================================================
*A:MTU-7210#
querier
Syntax
querier
Context
show>service>id>igmp-snooping
This command displays information on the IGMP snooping queriers for the VPLS service.
Description
Show Output — The following table describes the show output fields:
Output
Page 924
show service id 100 igmp-snooping proxy-db detail
Label
SAP Id
IP address
Expires
Up time
Version
General Query
Interval
Query Response
Interval
Robust Count
Specifies the SAP ID of the service.
Specifies the IP address of the querier.
The time left, in seconds, that the query will expire.
The length of time the query has been enabled.
The configured version of IGMP.
The frequency at which host-query packets are transmitted.
The time to wait to receive a response to the host-query message
from the host.
Specifies the value used to calculate several IGMP message intervals.
Description
7210 SAS M Services Guide