Alcatel-Lucent 7210 SAS M Service Manual page 722

Show, Clear, Debug Commands
sap-using
Syntax sap-using [sap sap-id]
sap-using interface [ip-address | ip-int-name]
sap-using [ingress | egress] filter filter-id
sap-using [ingress | egress] qos-policy qos-policy-id
Context show>service
This command displays SAP information.
Description
If no optional parameters are specified, the command displays a summary of all defined SAPs.
The optional parameters restrict output to only SAPs matching the specified properties.
sap-id — Specifies the physical port identifier portion of the SAP definition. See
Parameters
interface — Specifies matching SAPs with the specified IP interface.
ip-address — The IP address of the interface for which to display matching SAPs.
ip-int-name — The IP interface name for which to display matching SAPs.
ingress — Specifies matching an ingress policy.
egress — Specifies matching an egress policy.
qos-policy qos-policy-id — The ingress or egress QoS Policy ID for which to display matching
filter filter-id — The ingress or egress filter policy ID for which to display matching SAPs.
Show Service SAP — The following table describes show service SAP output fields:
Output
Page 722
Command Descriptions on page 939
1.0.0.0 — 223.255.255.255
Values
SAPs.
1 — 65535
Values
1 — 65535
Values
Label
Port ID
Svc ID
SapMTU
I.QoS
I.MAC/IP
E.QoS
E.Mac/IP
A.Pol
Adm
for command syntax.
The ID of the access port where the SAP is defined.
The service identifier.
The SAP MTU value.
The SAP ingress QoS policy number specified on the ingress SAP.
The MAC or IP filter policy ID applied to the ingress SAP.
The SAP egress QoS policy number specified on the egress SAP.
The MAC or IP filter policy ID applied to the egress SAP
The accounting policy ID assigned to the SAP.
The desired state of the SAP.
Common CLI
Description
7210-SAS M Services Guide