Alcatel-Lucent 7210 SAS M Service Manual page 617

by indicating the maximum number of redirect messages that can be issued on the interface for a
given time interval.
By default, generation of ICMP redirect messages is enabled at a maximum rate of 100 per 10 second
time interval.
The no form of this command disables the generation of icmp redirects on the router interface.
redirects 100 10 — Maximum of 100 redirect messages in 10 seconds.
Default
number — The maximum number of ICMP redirect messages to send. This parameter must be
Parameters
seconds — The time frame in seconds used to limit the seconds of ICMP redirect messages that can
ttl-expired
Syntax ttl-expired number seconds
no ttl-expired
Context config>service>vprn>if>icmp
config>service>vprn>sub-if>grp-if>icmp
config>service>vprn>nw-if>icmp#
Configures the rate Internet Control Message Protocol (ICMP) TTL expired messages are issued by
Description
the IP interface.
By default, generation of ICMP TTL expired messages is enabled at a maximum rate of 100 per 10
second time interval.
The no form of this command disables the limiting the rate of TTL expired messages on the router
interface.
ttl-expired 100 10
Default
number — The maximum number of ICMP TTL expired messages to send, expressed as a decimal
Parameters
seconds — The time frame in seconds used to limit the number of ICMP TTL expired messages that
7210 SAS M Services Guide
specified with the seconds parameter.
10 — 1000
Values
be issued.
1 — 60
Values
integer. This parameter must be specified with the seconds parameter.
10 — 1000
Values
can be issued, expressed as a decimal integer.
1 — 60
Values
Virtual Private Routed Network Services
Page 617