Alcatel-Lucent 7210 SAS M Service Manual page 706

Show, Clear, Debug Commands
Page 706
Label
SDP Delivery Mech-
anism
Number of SDPs
Service Access Points
Service Id
Port Id
Description
Encap
Admin State
Oper State
Last Changed
Admin MTU
Oper MTU
Ingress qos-pol-
icy
Egress qos-policy
Ingress Filter-Id
Egress Filter-Id
Multi Svc Site
Ingress sched-
policy
Egress sched-pol-
icy
Acct. Pol
Collect Stats
SAP Statistics
Dropped
Description (Continued)
When the SDP type is MPLS, a list of LSPs used to reach the far-end
router displays. All the LSPs in the list must terminate at the IP address
specified in the far-end field.
If the SDP type is GRE, then the following message displays:
"SDP Delivery Mechanism is not MPLS"
The total number SDPs applied to this service ID.
The service identifier.
The ID of the access port where this SAP is defined.
Generic information about the SAP.
The value of the label used to identify this SAP on the access port.
The desired state of the SAP.
The operating state of the SAP.
The date and time of the last change.
The largest service frame size (in octets) that can be transmitted through
this SDP to the far-end router, without requiring the packet to be frag-
mented.
The actual largest service frame size (in octets) that can be transmitted
through this SDP to the far-end router, without requiring the packet to
be fragmented.
The SAP ingress QoS policy ID.
The SAP egress QoS policy ID.
The SAP ingress filter policy ID.
The SAP egress filter policy ID.
Indicates the multi-service site that the SAP is a member.
Indicates the ingress QoS scheduler for the SAP.
Indicates the egress QoS scheduler for the SAP.
Indicates the accounting policy applied to the SAP.
Specifies whether accounting statistics are collected on the SAP.
The number of packets or octets dropped.
7210-SAS M Services Guide