Alcatel-Lucent 7210 SAS M Service Manual page 95

Global Service Configuration Commands
Generic Commands
shutdown
Syntax [no] shutdown
Context config>dot1ag>mep
config>service>sdp
config>service>sdp>keep-alive
This command administratively disables an entity. When disabled, an entity does not change, reset, or
Description
remove any configuration settings or statistics.
The operational state of the entity is disabled as well as the operational state of any entities contained
within. Many objects must be shut down before they may be deleted.
Services are created in the administratively down (shutdown) state. When a no shutdown command
is entered, the service becomes administratively up and then tries to enter the operationally up state.
Default administrative states for services and service entities is described below in Special Cases.
The no form of this command places the entity into an administratively enabled state.
Service Admin State — Bindings to an SDP within the service will be put into the out-of-service
Special Cases
state when the service is shutdown. While the service is shutdown, all customer packets are dropped
and counted as discards for billing and debugging purposes.
SDP (global) — When an SDP is shutdown at the global service level, all bindings to that SDP are
put into the out-of-service state and the SDP itself is put into the administratively and operationally
down states. Packets that would normally be transmitted using this SDP binding will be discarded and
counted as dropped packets.
SDP (service level) — Shutting down an SDP within a service only affects traffic on that service
from entering or being received from the SDP. The SDP itself may still be operationally up for other
services.
SDP Keepalives — Enables SDP connectivity monitoring keepalive messages for the SDP ID.
Default state is disabled (shutdown) in which case the operational state of the SDP-ID is not affected
by the keepalive message state.
7210 SAS M Services Guide
Subscriber Services
Page 95