Alcatel-Lucent 7210 SAS M Service Manual page 376

Virtual Private LAN Services
customer customer-id — Specifies the customer ID number to be associated with the service. This
vpls vpn
m-vpls — Specifies a management VPLS.
create — This keyword is mandatory while creating a VPLS service.
customer-vid vlan-id — Defines the dot1q VLAN ID to be specified while creating the local Dot1q
dot1q-preserve — Specifies that the allowed SAP in the service are Dot1q. The Dot1q ID is not
null-star — Specifies that the allowed SAP in the service which can be Null SAP,dot1q Default
bgp
Syntax bgp
Context config>service>vpls
This command enables the context to configure the BGP related parameters to BGP AD.
block-on-mesh-failure
Syntax [no] block-on-mesh-failure
Context config>service>vpls>spoke-sdp
config>service>vpls>endpoint
This command enables blocking (brings the entity to an opererationally down state) after all
Description
configured SDPs or endpoints are in opererationally down state. This event is signalled to
corresponding T-LDP peer by withdrawing service label (status-bit-signaling non-capable peer) or by
setting "PW not forwarding" status bit in T-LDP message (status-bit-signaling capable peer).
disabled
Default
bpdu-translation
Syntax bpdu-translation {auto | pvst | stp}
no bpdu-translation
Context config>service>vpls>spoke-sdp
Page 376
parameter is required on service creation and optional for service editing or deleting.
1 — 2147483647
Values
SAP for svc-sap-type dot1q-preserve.
1 — 4094
Values
stripped after packets matches the SAP.
null-star
Default
SAP,Q.* SAP or Default QinQ SAP.
svc-sap-type-Specifies the type of service and allowed SAPs in the service.
7210 SAS M Services Guide