Alcatel-Lucent 7210 SAS M Service Manual page 902

Show, Clear, Debug Commands
Ingress qos-policy : 1
-------------------------------------------------------------------------------
Aggregate Policer
-------------------------------------------------------------------------------
rate
-------------------------------------------------------------------------------
Ingress QoS Classifier Usage
-------------------------------------------------------------------------------
Classifiers Allocated: 4
Classifiers Used
-------------------------------------------------------------------------------
Sap Statistics
-------------------------------------------------------------------------------
Ingress Stats:
Egress Stats:
Extra-Tag Drop Stats:
-------------------------------------------------------------------------------
Sap per Meter stats
-------------------------------------------------------------------------------
Ingress Meter 1 (Unicast)
For. InProf
For. OutProf
Ingress Meter 11 (Multipoint)
For. InProf
For. OutProf
===============================================================================
sdp
Note : SDP commands are not supported by 7210 SAS-M devices configured in Access uplink mode.
Syntax sdp [sdp-id | far-end ip-addr] [detail]
Context show>service>id
This command displays information for the SDPs associated with the service. If no optional
Description
parameters are specified, a summary of all associated SDPs is displayed.
sdp-id — Displays only information for the specified SDP ID.
Parameters
far-end ip-addr — Displays only SDPs matching with the specified far-end IP address.
detail — Displays detailed SDP information.
Show Service-ID SDP — The following table describes show service-id SDP output fields.
Output
Page 902
: n/a
: 2
Packets
142761481188
0
n/a
Packets
: 17
: 0
: 61
: 142761547917
All SDPs
Default
1 — 17407
Values
SDPs with any far-end IP address.
Default
burst : n/a
Meters Allocated : 2
Meters Used : 2
Octets
9707780720784
0
n/a
Octets
1162
0
4148
9707785259394
7210 SAS M Services Guide