Alcatel-Lucent 7210 SAS M Service Manual page 679

Note : SDP commands are not supported by 7210 SAS-M devices configured in Access uplink mode.
sdp [sdp-id | far-end ip-address] [detail | keep-alive-history]
Syntax
Context show>service
This command displays SDP information.
Description
If no optional parameters are specified, a summary SDP output for all SDPs is displayed.
sdp-id — The SDP ID for which to display information.
Parameters
Default
Values
far-end ip-address — Displays only SDPs matching with the specified far-end IP address.
Default
detail — Displays detailed SDP information.
Default
keep-alive-history — Displays the last fifty SDP keepalive events for the SDP.
Default
Show Service SDP — The following table describes show service SDP output fields.
Output
SDP Id
Description
Admin Path MTU
Opr Path MTU
Far End
Delivery
IP address
Adm
Admin State
7210 SAS M Services Guide
All SDPs.
1 — 17407
SDPs with any far-end IP address.
SDP summary output.
SDP summary output.
Label
The SDP identifier.
Displays a text string describing the SDP.
Displays the desired largest service frame size (in octets) that can be trans-
mitted through this SDP to the far-end ESR, without requiring the packet to
be fragmented. The default value of zero indicates that the path MTU should
be computed dynamically from the corresponding MTU of the tunnel.
Displays the actual largest service frame size (in octets) that can be transmit-
ted through this SDP to the far-end ESR, without requiring the packet to be
fragmented. In order to be able to bind this SDP to a given service, the value
of this object minus the control word size (if applicable) must be equal to or
larger than the MTU of the service, as defined by its service MTU.
Displays the far end IP address.
The type of delivery used by the SDP: MPLS.
Specifies the IP address of the remote end of the MPLS tunnel defined by
this SDP.
The desired state of the SDP.
Service Commands
Description
Page 679