Alcatel-Lucent 7210 SAS M Service Manual page 425

split-horizon-group group-name — Specifies the name of the split horizon group to which the SDP
vc-type — This command overrides the default VC type signaled for the spoke or mesh binding to
vlan — Defines the VC type as VLAN. The ethernet and vlan keywords are mutually exclusive.
egress
Syntax egress
Context config>service>vpls>mesh-sdp
config>service>vpls>spoke-sdp
This command configures the egress SDP context.
Description
ingress
Syntax ingress
Context config>service>vpls>mesh-sdp
config>service>vpls>spoke-sdp
This command configures the ingress SDP context.
Description
vc-label
Syntax [no] vc-label vc-label
Context config>service>vpls>mesh-sdp>egress
config>service>vpls>spoke-sdp>egress
This command configures the egress VC label.
Description
vc-label — A VC egress value that indicates a specific connection.
Parameters
7210 SAS M Services Guide
belongs.
the far end of the SDP. The VC type is a 15 bit-quantity containing a value which represents the
type of VC. The actual signaling of the VC type depends on the signaling parameter defined for
the SDP. If signaling is disabled, the vc-type command can still be used to define the dot1q value
expected by the far-end provider equipment. A change of the bindings VC type causes the
binding to signal the new VC type to the far end when signaling is enabled.
VC types are derived according to IETF draft-martini-l2circuit-trans-mpls.
• The VC type value for Ethernet is 0x0005.
• The VC type value for an Ethernet VLAN is 0x0004.
ether, vlan
Values
When the VC type is not defined then the default is Ethernet for spoke SDP bindings.
The VLAN VC-type requires at least one dot1Q tag within each encapsulated Ethernet packet
transmitted to the far end.
Virtual Private LAN Services
Page 425