This command configures ICMPv6 redirect messages. When enabled, ICMPv6 redirects are
Description
generated when routes are not optimal on this router and another router on the same subnetwork has a
better route in order to alert that node that a better route is available.
When disabled, ICMPv6 redirects are not generated.
100 10
Default
number — Specifies the number of version 6 redirects are to be issued in the time frame specified by
seconds — Specifies the time frame in seconds that is used to limit the number of version 6 redirects
time-exceeded
Syntax
time-exceeded [number seconds]
no time-exceeded
Context
config>service>ies>if>ipv6>icmp6
This command specifies whether "time-exceeded" ICMPv6 messages should be sent. When enabled,
Description
ICMPv6 "time-exceeded" messages are generated by this interface.
When disabled, ICMPv6 "time-exceeded" messages are not sent.
100 10
Default
number — Specifies the number of "time-exceeded" ICMPv6 messages are to be issued in the time
seconds — Specifies the time frame in seconds that is used to limit the number of "time-exceeded"
unreachables
Syntax
unreachables [number seconds]
no unreachables
Context
config>service>ies>if>ipv6>icmp6
7210-SAS M Services Guide
the seconds parameter.
10 — 1000
Values
100
Default
issued.
1 — 60
Values
10
Default
frame specified by the seconds parameter.
10 — 1000
Values
100
Default
ICMPv6 message to be issued.
1 — 60
Values
10
Default
IES Service Configuration Commands
Page 531