Alcatel-Lucent 7210 SAS M Service Manual page 436

Virtual Private LAN Services
If the send-query command is not configured, the version command has no effectThe version used
on that SAP orwill be the version of the querier.
Note: IGMP V3 is supported only on 7210 SAS-M devices configured in access-uplink mode. IGMP
V3 is not supported on 7210 SAS-M devices configured in network mode.
version — Specify the IGMP version.
Parameters
to-sap
Syntax to-sap sap-id
no to-sap
Context config>service>vpls>sap>igmp-snooping>mvr
Description
This command configures the SAP to which the multicast data needs to be copied.
In some scenarios, the multicast traffic should not be copied from the MVR VPLS to the SAP on
which the IGMP message was received (standard MVR behaviour) but to another SAP.
no to-sap
Default
Parameters
Page 436
sap-id — Specifies the SAP to which multicast channels should be copied.
7210 SAS M Services Guide