Alcatel-Lucent 7210 SAS M Service Manual page 868

Show, Clear, Debug Commands
1/1/1:200
1/1/3:100.200
1/1/1:300
-------------------------------------------------------------------------------
Number of SAPs : 5
-------------------------------------------------------------------------------
*A:ALU_SIM2>config>service>vpls#
sdp
Note : SDP commands are not supported by 7210 SAS-M devices configured in uplink mode.
Syntax sdp [sdp-id | far-end ip-addr] [detail | keep-alive-history]
Context show>service>id
This command displays information for the SDPs associated with the service.
Description
If no optional parameters are specified, a summary of all associated SDPs is displayed.
sdp-id — Displays only information for the specified SDP ID. An SDP is a logical mechanism that
Parameters
far-end ip-addr — Displays only SDPs matching with the specified system IP address of the far-end
detail — Displays detailed SDP information.
Show Service SDP — The following table describes show service-id SDP output fields.
Output
Page 868
ties a far-end 7210 SAS M to a particular service without having to specifically define far end
SAPs. Each SDP represents a method to reach a 7210 SAS M router.
All SDPs.
Default
1 — 17407
Values
destination 7210 SAS M router for the Service Distribution Point (SDP) that is the termination
point for a service.
SDPs with any far-end IP address.
Default
Label
Sdp Id
Type
VC Type
VC Tag
I. Lbl
Admin Path MTU
200 1
200 1
300 1
The SDP identifier.
Indicates whether the SDP is a spoke.
Displays the VC type, ether or vlan.
Displays the explicit dot1Q value used when encapsulating to the SDP
far end.
The VC label used by the far-end device to send packets to this device
in this service by the SDP.
The operating path MTU of the SDP is equal to the admin path MTU
(when one is set) or the dynamically computed tunnel MTU, when no
admin path MTU is set (the default case.)
none 1none Up
none 1none Up
none 1none Up
Description
7210 SAS M Services Guide
Up
Up
Up