Alcatel-Lucent 7210 SAS M Service Manual page 649

priority
Syntax priority priority
no priority priority
Context config>router>pim>rp>local
config>service>vprn>pim>rp>rp-candidate
This command defines the priority used to become the rendezvous point (RP). The higher the priority
Description
value, the more likely that this router will become the RP.
Use the no form of this command to revert to the default value.
1
Default
priority — Specify the priority to become the designated router. The higher the value the more likely
Parameters
the router will become the RP.
static
Syntax static
Context config>service>vprn>pim>rp
This command enables access to the context to configure a static rendezvous point (RP) of a PIM-SM
Description
protocol instance.
none
Default
address
Syntax [no] address ip-address
Context config>service>vprn>pim>rp>static
This command configures the static rendezvous point (RP) address.
Description
The override option specifies that dynamically learned RPs have less priority then this static entry, by
default dynamic learned RPs take preference over static configured RPs.
The no form of this command removes the static RP entry from the configuration.
none
Default
7210 SAS M Services Guide
0 — 255
Values
Virtual Private Routed Network Services
Page 649