Alcatel-Lucent 7210 SAS M Service Manual page 604

VPRN Service Configuration Commands
application
Syntax application app [ip-int-name|ip-address]
no application app
Context config>service>vprn>source-address
This command specifies the source address and application.
Description
app — Specify the application name.
Parameters
ip-int-name | ip-address — Specifies the name of the IP interface or IP address. If the string contains
static-route
Syntax [no] static-route {ip-prefix/prefix-length | ip-prefix netmask} [preference preference] [metric
metric] [tag tag] [enable | disable] {next-hop ip-int-name | ip-address | ipsec-tunnel ipsec-
tunnel-name} [bfd-enable | {cpe-check cpe-ip-address [interval seconds] [drop-count
count] [log]}]
[no] static-route {ip-prefix/prefix-length | ip-prefix netmask} [preference preference] [metric
metric] [tag tag] [enable | disable] indirect ip-address [cpe-check cpe-ip-address [interval
seconds][drop-count count] [log]]
[no] static-route {ip-prefix/prefix-length | ip-prefix netmask} [preference preference] [metric
metric] [tag tag] [enable | disable] black-hole
Context config>service>vprn
This command creates static route entries within the associated router instance. When configuring a
Description
static route, either next-hop, indirect or black-hole must be configured.
The no form of the command deletes the static route entry. If a static route needs to be removed when
multiple static routes exist to the same destination, then as many parameters to uniquely identify the
static route must be entered.
If a CPE connectivity check target address is already being used as the target address in a different
static route, then cpe-check parameters must match. If they do not, the new configuration command
will be rejected.
If a static-route command is issued with no cpe-check target but the destination prefix/netmask and
next-hop matches a static route that did have an associated cpe-check, the cpe-check test will be
removed from the associated static route.
No static routes are defined.
Default
ip-prefix — The destination address of the aggregate route in dotted decimal notation.
Parameters
Page 604
telnet, ssh, traceroute, ping
Values
special characters (#, $, spaces, etc.), the entire string must be enclosed within double quotes.
ipv4-prefix
Values
ipv4-prefix-length
a.b.c.d (host bits must be 0)
0 — 32
7210 SAS M Services Guide