Alcatel-Lucent 7210 SAS M Service Manual page 607

Hide thumbs Also See for 7210 SAS M:
Table of Contents

Advertisement

bfd-enable — Associates the state of the static route to a BFD session between the local system and
cpe-check target-ip-address — This parameter specifies the IP address of the target CPE device.
vrf-export
Syntax
vrf-export policy [policy...]
no vrf-export
Context
config>service>vprn
This command specifies the export policies to control routes exported from the local VPN routing/
Description
forwarding (VRF) to other VRFs on the same or remote PE routers (via MP-BGP).
The no form of the command removes all route policy names from the export list.
None — No routes are exported from the VRF by default.
Default
policy — The route policy statement name.
Parameters
vrf-import
Syntax
vrf-import policy [policy...]
no vrf-import
Context
config>service>vprn
This command sets the import policies to control routes imported to the local VPN routing/
Description
forwarding (VRF) from other VRFs on the same or remote PE routers (via MP-BGP). BGP-VPN
routes imported with a vrf-import policy will use the BGP preference value of 170 when imported
from remote PE routers, or retain the protocol preference value of the exported route when imported
from other VRFs on the same router, unless the preference is changed by the policy.
The no form of the command removes all route policy names from the import list
None — No routes are accepted into the VRF by default.
Default
policy — The route policy statement name.
Parameters
7210 SAS M Services Guide
1..4294967295
Values
the configured nexthop. This keyword cannot be configured if the nexthop is indirect or a
blackhole keywords are specified.
ICMP pings will be sent to this target IP address. This parameter must be configured to enable
the CPE connectivity feature for the associated static route. The target-ip-address cannot be in the
same subnet as the static route subnet itself to avoid possible circular references. This option is
mutually exclusive with BFD support on a given static route.
no cpe-check enabled
Default
Virtual Private Routed Network Services
Page 607

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents