Alcatel-Lucent 7210 SAS M Service Manual page 648

VPRN Service Configuration Commands
rp-candidate
Syntax rp-candidate
Context config>service>vprn>pim>rp
This command enables the context to configure the candidate rendezvous point (RP) parameters.
Description
Enabled when PIM is enabled.
Default
group-range
Syntax [no] group-range {grp-ip-address/mask | grp-ip-address [netmask]}
Context config>service>vprn>pim>rp>rp-candidate
config>service>vprn>pim>ssm
This command configures the group address or range of group addresses for which this router can be
Description
the rendezvous point (RP).
Use the no form of this command to remove the group address or range of group addresses for which
this router can be the RP from the configuration.
none
Default
group-ip-address — Specify the addresses or address ranges that this router can be an RP.
Parameters
mask — Specify the address mask with the address to define a range of addresses.
netmask — Specify the subnet mask in dotted decimal notation.
holdtime
Syntax holdtime holdtime
no holdtime holdtime
Context config>service>vprn>pim>rp>rp-candidate
Use this command to define the length of time neighboring router consider this router to be up.
Description
Use the no form of this command to revert to the default value.
150
Default
holdtime — Specify the length of time, in seconds, that neighbor should consider the sending router to
Parameters
be operational.
Page 648
0.0.0.0 — 255.255.255.255 (network bits all 1 and host bits all 0)
Values
0 — 255
Values
7210 SAS M Services Guide