Alcatel-Lucent 7210 SAS M Service Manual page 805

sdp
Note : SDP commands are not supported by 7210 SAS-M devices configured in uplink mode.
sdp [sdp-id | far-end ip-address] [detail | keep-alive-history]
Syntax
Context show>service
This command displays SDP information.
Description
If no optional parameters are specified, a summary SDP output for all SDPs is displayed.
sdp-id — The SDP ID for which to display information.
Parameters
far-end ip-address — Displays only SDPs matching with the specified far-end IP address.
detail — Displays detailed SDP information.
keep-alive-history — Displays the last fifty SDP keepalive events for the SDP.
Show Service SDP — The following table describes show service SDP output fields:
Output
7210 SAS M Services Guide
All SDPs.
Default
1 — 17407
Values
SDPs with any far-end IP address.
Default
SDP summary output.
Default
SDP summary output.
Default
Label
SDP Id
Adm MTU
Opr MTU
IP address
Adm
Admin State
Opr
Oper State
Deliver
Delivery
Flags
The SDP identifier.
Specifies the desired largest service frame size (in octets) that can be
transmitted through this SDP to the far-end router, without requiring
the packet to be fragmented.
Specifies the actual largest service frame size (in octets) that can be
transmitted through this SDP to the far-end router, without requiring
the packet to be fragmented.
Specifies the IP address of the remote end of the GRE or MPLS tunnel
defined by this SDP.
Specifies the desired state of the SDP.
Specifies the operating state of the SDP.
Specifies the type of delivery used by the SDP: GRE or MPLS.
Specifies all the conditions that affect the operating status of this SDP.
VLL Show Commands
Description
Page 805