Alcatel-Lucent 7210 SAS M Service Manual page 605

netmask — The subnet mask in dotted decimal notation.
ip-int-name — The name of the IP interface. Interface names must be unique within the group of
ip-address — The IP address of the IP interface. The ip-addr portion of the address command
enable — Static routes can be administratively enabled or disabled. Use the enable parameter to re-
disable — Static routes can be administratively enabled or disabled. Use the disable parameter to
interval seconds — This optional parameter specifies the interval between ICMP pings to the target
IP address.
drop-count count — This optional parameter specifies the number of consecutive ping-replies that
must be missed to declare the CPE down and to de-active the associated static route.
log — This optional parameter enables the ability to log transitions between active and in-active
based on the CPE connectivity check. Events should be sent to the system log, syslog and SNMP
traps.
next-hop [ip-address | ip-int-name] — Specifies the directly connected next hop IP address used to
7210 SAS M Services Guide
0.0.0.0 — 255.255.255.255 (network bits all 1 and host bits all 0)
Values
defined IP interfaces for config router interface and config service ies interface commands. An
interface name cannot be in the form of an IP address. If the string contains special characters (#,
$, spaces, etc.), the entire string must be enclosed with
specifies the IP host address that will be used by the IP interface within the subnet. This address
must be unique within the subnet and specified in dotted decimal notation.
ipv4-address
Values
enable a disabled static route. In order to enable a static route, it must be uniquely identified by
the IP address, mask, and any other parameter that is required to identify the exact static route.
The administrative state is maintained in the configuration file.
enable
Default
disable a static route while maintaining the static route in the configuration. In order to enable a
static route, it must be uniquely identified by the IP address, mask, and any other parameter that
is required to identify the exact static route.
The administrative state is maintained in the configuration file.
enable
Default
1 —255 seconds
Values
1 seconds
Default
Value range: 1 —255
Values
3
Default
reach the destination. If the next hop is over an unnumbered interface, the ip-int-name of the
unnumbered interface (on this node) can be configured.
The next-hop keyword and the indirect or black-hole keywords are mutually exclusive. If an
identical command is entered (with the exception of either the indirect or black-hole
parameters), then this static route will be replaced with the newly entered command, and unless
specified, the respective defaults for preference and metric will be applied.
Virtual Private Routed Network Services
a.b.c.d (host bits must be 0)
Page 605