Alcatel-Lucent 7210 SAS M Service Manual page 866

Show, Clear, Debug Commands
ingress-label
Syntax ingress-label start-label [end-label]
Context show>service
Display services using the range of ingress labels.
Description
If only the mandatory start-label parameter is specified, only services using the specified label are
displayed.
If both start-label and end-label parameters are specified, the services using the range of labels X
where start-label <= X <= end-label are displayed.
Use the show router ldp bindings command to display dynamic labels.
start-label — The starting ingress label value for which to display services using the label range. If
Parameters
end-label — The ending ingress label value for which to display services using the label range.
Show Service Ingress-Label — The following table describes show service ingress-label output
Output
fields.
Page 866
only start-label is specified, services only using start-label are displayed.
0, 2048 — 131071
Values
The start-label value.
Default
2049 — 131071
Values
Label
Svc ID
SDP Id
Type
I.Lbl
E.Lbl
Number of Bindings
Found
The service identifier.
The SDP identifier.
Indicates whether the SDP is spoke.
The ingress label used by the far-end device to send packets to this
device in this service by the SDP.
The egress label used by this device to send packets to the far-end
device in this service by the SDP.
The number of SDP bindings within the label range specified.
Description
7210 SAS M Services Guide