Alcatel-Lucent 7210 SAS M Service Manual page 870

Show, Clear, Debug Commands
sdp-using
Syntax sdp-using [sdp-id[:vc-id] | far-end ip-address]
Context show>service
This command displays services using SDP or far-end address options.
Description
sdp-id — Displays only services bound to the specified SDP ID.
Parameters
vc-id — The virtual circuit identifier.
far-end ip-address — Displays only services matching with the specified far-end IP address.
Show Service SDP Using — The following table describes service-using output fields.
Output
Sample Output
*A:ALA-1# show service sdp-using 300
===============================================================================
Service Destination Point (Sdp Id : 300)
===============================================================================
SvcId
-------------------------------------------------------------------------------
2
-------------------------------------------------------------------------------
Number of SDPs : 51
-------------------------------------------------------------------------------
*A:ALA-1#
Page 870
1 — 17407
Values
1 — 4294967295
Values
Services with any far-end IP address.
Default
Label
Svc ID
Sdp ID
Type
Far End
Oper State
Ingress Label
Egress Label
SdpId
300:2
The service identifier.
The SDP identifier.
Specifies the type of SDP: Spoke.
The far-end address of the SDP.
The operational state of the service.
The label used by the far-end device to send packets to this device in
this service by this SDP.
The label used by this device to send packets to the far-end device in
this service by this SDP.
Type Far End
Spok 10.0.0.13
Description
Opr State I.Label
Up 131070
7210 SAS M Services Guide
E.Label
131070