Pim Commands - Alcatel-Lucent 7210 SAS M Service Manual

PIM Commands

pim
Syntax [no] pim
Context config>service>vprn
This command configures a Protocol Independent Multicast (PIM) instance in the VPRN service.
Description
When an PIM instance is created, the protocol is enabled. PIM is used for multicast routing within the
network. Devices in the network can receive the multicast feed requested and non-participating
routers can be pruned. The supports PIM sparse mode (PIM-SM).
The no form of the command deletes the PIM protocol instance removing all associated configuration
parameters.
none
Default
apply-to
Syntax apply-to {all | none}
Context config>service>vprn>pim
This command creates a PIM interface with default parameters.
Description
If a manually created interface or modified interface is deleted, the interface will be recreated when
the apply-to command is executed. If PIM is not required on a specific interface, then execute a
shutdown command.
The apply-to command is saved first in the PIM configuration structure, all subsequent commands
either create new structures or modify the defaults as created by the apply-to command.
none (keyword)
Default
all — Specifies that all VPRN and non-VPRN interfaces are automatically applied in PIM.
Parameters
none — No interfaces are automatically applied in PIM. PIM interfaces must be manually
7210 SAS M Services Guide
configured.
Virtual Private Routed Network Services
Page 635