Alcatel-Lucent 7210 SAS M Service Manual page 400

Virtual Private LAN Services
hello-time
Syntax hello-time hello-time
no hello-time
Context config>service>vpls>stp
config>template>vpls-template>stp
This command configures the Spanning Tree Protocol (STP) hello time for the Virtual Private LAN
Description
Service (VPLS) STP instance.
The hello time parameter defines the default timer value that controls the sending interval between
BPDU configuration messages by this bridge, on ports where this bridge assumes the designated role.
The active hello time for the spanning tree is determined by the root bridge (except when the STP is
running in RSTP mode, then the hello time is always taken from the locally configured parameter).
The configured hello-time can also be used to calculate the forward delay. See
The no form of this command returns the hello time to the default value.
2 seconds
Default
hello-time — The hello time for the STP instance in seconds.
Parameters
hold-count
Syntax hold-count BDPU tx hold count
no hold-count
Context config>service>vpls>stp
config>template>vpls-template>stp
This command configures the peak number of BPDUs that can be transmitted in a period of one
Description
second.
The no form of this command returns the hold count to the default value
6
Default
BDPU tx hold count — The hold count for the STP instance in seconds.
Parameters
Page 400
1 — 10
Values
1 — 10
Values
auto-edge on page
7210 SAS M Services Guide
398.