Vprn Show Commands - Alcatel-Lucent 7210 SAS M Service Manual

VPRN Show Commands

VPRN
egress-label
Syntax egress-label start-label [end-label]
Context show>service
Display services using the range of egress labels.
Description
If only the mandatory start-label parameter is specified, only services using the specified label are
displayed.
If both start-label and end-label parameters are specified, the services using the range of labels X
where start-label <= X <= end-label are displayed.
Use the show router ldp bindings command to display dynamic labels.
start-label — The starting egress label value for which to display services using the label range. If
Parameters
end-label — The ending egress label value for which to display services using the label range.
Show Service Egress Command Output — The following table describes show service
Output
egress label output fields.
7210-SAS M Services Guide
only egress-label1 is specified, services only using egress-label1 are displayed.
0 | 2048 — 131071
Values
The egress-label1 value.
Default
2049 — 131071
Values
Label
Svc Id
Sdp Id
Type
I. Lbl
E. Lbl
Number of bindings
found
The ID that identifies a service.
The ID that identifies an SDP.
Indicates whether the SDP binding is a spoke or a mesh.
The VC label used by the far-end device to send packets to this device
in this service by the SDP.
The VC label used by this device to send packets to the far-end device
in this service by the SDP.
The total number of SDP bindings that exist within the specified egress
label range.
VPRN Show Commands
Description
Page 719