Vll Debug Commands - Alcatel-Lucent 7210 SAS M Service Manual

Show, Clear, Debug Commands

VLL Debug Commands

id
Syntax id service-id
Context debug>service
This command debugs commands for a specific service.
Description
service-id — The ID that uniquely identifies a service.
Parameters
sap
Syntax [no] sap sap-id
Context debug>service>id
This command enables debugging for a particular SAP.
Description
sap-id — Specifies the SAP ID.
Parameters
event-type
Syntax [no] event-type {arp | config-change |oper-status-change}
Context debug>service>id
This command enables a particular debugging event type.
Description
The no form of the command disables the event type debugging.
arp — Displays ARP events.
Parameters
config-change — Debugs configuration change events.
svc-oper-status-change — Debugs service operational status changes.
Sample Output
A:bksim180# debug service id 1000 sap 1/7/1 event-type arp
DEBUG OUTPUT show on CLI is as follows:
3 2008/11/17 18:13:24.35 UTC MINOR: DEBUG #2001 Base Service 1000 SAP 1/7/1 "Service
1000 SAP 1/7/1:
RX: ARP_REQUEST (0x0001)
hwType
prType
hwLength
Page 858
: 0x0001
: 0x0800
: 0x06
7210 SAS M Services Guide