Alcatel-Lucent 7210 SAS M Service Manual page 319

Distributed VPLS SAPs
Note: Distributed VPLS service is not supported on 7210 SAS M devices configured in Access
uplink mode.
To configure a distributed VPLS service, you must configure service entities on originating and
far-end nodes. You must use the same service ID on all ends (for example, create a VPLS service
ID 9000 on ALA-1, ALA-2, and ALA-3). A distributed VPLS consists of a SAP on each
participating node and an SDP bound to each participating node.
For SDP configuration information, see
information, see
The following example displays a configuration of VPLS SAPs configured for ALA-1, ALA-2,
and ALA-3.
*A:ALA-3>config>service# info
----------------------------------------------
vpls 1150 customer 1 create
----------------------------------------------
*A:ALA-3>config>service#
7210 SAS M Services Guide
Configuring SDP Bindings on page
fdb-table-size 1000
fdb-table-low-wmark 5
fdb-table-high-wmark 80
local-age 60
stp
shutdown
exit
sap 1/1/1:1155 create
exit
sap 1/1/2:1150 create
exit
no shutdown
exit
Virtual Private LAN Services
Configuring an SDP on page
329.
71. For SDP binding
Page 319