Mep And Mip Support; Table 6: Eth-Cfm Support Matrix - Alcatel-Lucent 7210 SAS M Service Manual

Ethernet Connectivity Fault Management (ETH-CFM)

MEP and MIP Support

The following is a general table that indicates the ETH-CFM support for the different services and
endpoints. It is not meant to indicate the services that are supported or the requirements for those
services on the individual platforms.

Table 6: ETH-CFM Support Matrix

Epipe (Ethernet Access SAP/
SDP)
VPLS (Ethernet SAP/Spoke SDP)
RVPLS (Ethernet Access SAP
and Access-uplink SAP)
RVPLS (IES Interface)
PBB Epipe I-SAP
PBB I-VPLS I-SAP
PBB B-VPLS B-SAP
IES (Ethernet SAP )
VPRN (Ethernet SAP/SDP)
Note: Ethernet-Rings are not configurable under all service types. Any service restrictions for
MEP direction or MIP support will override the generic capability of the Ethernet-Ring MPs. For
more information on Ethernet-Rings, refer to the 7210 SAS M, X Interfaces Guide.
Note: An Ingress MIP or a Down MIP refers to an unidirectional MIP. In 7210, MIP is uni-
directional in that only CFM OAM packets received in the ingress direction is processed.
Note: Routed VPLS Service is supported only in 7210 SAS-M access-uplink mode. It is not
supported in 7210 SAS-M network mode.
Page 78
Service Description
Ethernet Point to Point
Multipoint Ethernet
Routed VPLS service
Routed VPLS service(IP
interface)
PBB Epipe service (SAP
endpoint)
PBB ELAN/I-VPLS service
(SAP endpoint)
PBB B-VPLS service (SAP
endpoint)
Internet Enhanced Service
Virtual Private Routed Network
7210 SAS M Services Guide
MEP/MIP Support
UP MEP (In 7210
SAS-M network mode
only), Down MEP
Down MEP, Ingress
MIPs, UP MEP (in
7210 SAS-M network
mode only)
None
None
UP MEP (In 7210
SAS-M network mode
only)
None
None
None
None