Alcatel-Lucent 7210 SAS M Service Manual page 862

Show, Clear, Debug Commands
Page 862
Label
Mac Move Rate
Mac Move Timeout
Table Size
Total Count
Learned Count
Static Count
Remote Age
Local Age
High WaterMark
Low WaterMark
Mac Learning
Discard Unknown
MAC Aging
MAC Pinning
Relearn Only
Total Service FDB
Total FDB Config-
ured Size
Description (Continued)
The maximum rate at which MAC's can be re-learned in this TLS ser-
vice, before the SAP where the moving MAC was last seen is automat-
ically disabled in order to protect the system against undetected loops
or duplicate MAC's.
The rate is computed as the maximum number of re-learns allowed in a
5 second interval. The default rate of 10 re-learns per second corre-
sponds to 50 re-learns in a 5 second period.
Indicates the time in seconds to wait before a SAP that has been dis-
abled after exceeding the maximum re-learn rate is re-enabled. A value
of zero indicates that the SAP will not be automatically re-enabled
after being disabled. If after the SAP is re-enabled it is disabled again,
the effective retry timeout is doubled in order to avoid thrashing.
The maximum number of learned and static entries allowed in the
FDB.
The current number of entries (both learned and static) in the FDB of
this service.
The current number of learned entries in the FDB of this service.
The current number of static entries in the FDB of this service.
The number of seconds used to age out FDB entries learned on an SDP.
These entries correspond to MAC addresses learned on remote SAPs.
The seconds used to age out FDB entries learned on local SAPs.
The utilization of the FDB table of this service at which a 'table full'
alarm is raised by the agent.
The utilization of the FDB table of this service at which a 'table full'
alarm is cleared by the agent.
Specifies whether the MAC learning process is enabled in this service.
Specifies whether frames received with an unknown destination MAC
are discarded in this service.
Specifies whether the MAC aging process is enabled in this service.
Specifies whether MAC pinning is enabled in this service.
When enabled, indicates that either the FDB table of this service is full
or that the maximum system-wide number of MAC's supported by the
agent has been reached, and thus MAC learning is temporary disabled,
and only MAC re-learns can take place.
The current number of service FDBs configured on this node.
The sum of configured FDBs.
7210 SAS M Services Guide