Vll Show Commands - Alcatel-Lucent 7210 SAS M Service Manual

VLL Show Commands

VLL
sap-using
Syntax sap-using [sap sap-id]
sap-using interface [ip-address | ip-int-name]
sap-using [ingress | egress] filter filter-id
sap-using [ingress | egress] qos-policy qos-policy-id
sap-using encap-type encap-type
Context show>service
This command displays SAP information.
Description
If no optional parameters are specified, the command displays a summary of all defined SAPs.
The optional parameters restrict output to only SAPs matching the specified properties.
ip-addr — The IP address of the interface for which to display matching SAPs.
Parameters
ip-int-name — Specifies the IP interface name for which to display matching SAPs.
ingress — Specifies matching an ingress policy.
ingress — Specifies matching an ingress policy.
ingress — Specifies matching an ingress policy.
egress — Specifies matching an egress policy.
qos-policy qos-policy-id — The ingress QoS Policy ID for which to display matching SAPs.
filter filter-id — The ingress or egress filter policy ID for which to display matching SAPs.
sap sap-id — Specifies the physical port identifier portion of the SAP definition. See Common CLI
encap-type encap-type — Displays the CEM encapsulation type.
Show Service SAP — The following table describes show service SAP output fields:
Output
7210 SAS M Services Guide
1.0.0.0 to 223.255.255.255
Values
1 — 65535
Values
1 — 65535
Values
Command Descriptions on page 939 for command syntax.
cem
Values
Label
Port ID
Svc ID
MTU
The ID of the access port where the SAP is defined.
The service identifier.
The port MTU value.
VLL Show Commands
Description
Page 801