Table 19: Final Disposition Of The Packet Based On Per Fc And Per Sap Policer Or Meter - Alcatel-Lucent 7210 SAS M Service Manual

VPRN Service Configuration Commands
The no form of this command removes any configured filter ID association with the SAP or IP
interface. The filter ID itself is not removed from the system unless the scope of the created filter is
set to local.
ip ip-filter-id — Specifies IP filter policy. The filter ID must already exist within the created IP filters.
Parameters
mac mac-filter-id — Specifies the MAC filter policy. The specified filter ID must already exist
aggregate-meter-rate
Syntax aggregate-meter-rate rate-in-kbps [burst burst-in-kbits]
no aggregate-meter-rate
Context config>service>vpls>sap>ingress
This command allows the user to configure the SAP aggregate policer. The rate of the SAP aggregate
Description
policer must be specified by the user. The user can optionally specify the burst size for the SAP
aggregate policer. The aggregate policer monitors the traffic on different FCs and determines the
destination of the packet. The packet is either forwarded to an identified profile or dropped.
The table below provides information about the final disposition of the packet based on the operating
rate of the per FC policer and the per SAP aggregate policer:

Table 19: Final Disposition of the packet based on per FC and per SAP policer or meter.

Page 624
1 — 65535
Values
within the created MAC filters. The filter policy must already exist within the created MAC
filters.
1— 65535
Values
Per FC meter Per FC
Operating Assigned
Rate Color
Within CIR Green
Within CIR Green
Above CIR, Yellow
Within PIR
Above CIR, Yellow
Within PIR
Above PIR Red
Above PIR Red
SAP aggre- SAP aggre-
gate meter gate meter
Operating color
Rate
Within PIR Green
Above PIR Red
Within PIR Green
Above PIR Red
Within PIR Green
Above PIR Red
7210 SAS M Services Guide
Final Packet
Color
Green or
In-profile
Green or
In-profile
Yellow or
Out-of-Profile
Red or
Dropped
Red or
Dropped
Red or
Dropped