Alcatel-Lucent 7210 SAS M Service Manual page 237

primary — Specifies to make this the primary spoke SDP.
vc-label
Syntax [no] vc-label vc-label
Context config>service>cpipe>spoke-sdp>egress
config>service>epipe>spoke-sdp>egress
This command configures the egress VC label.
Description
vc-label — A VC egress value that indicates a specific connection.
Parameters
vc-label
Syntax [no] vc-label vc-label
Context config>service>cpipe>spoke-sdp>ingress
config>service>epipe>spoke-sdp>ingress
This command configures the ingress VC label.
Description
vc-label — A VC ingress value that indicates a specific connection.
Parameters
vlan-vc-tag
Syntax vlan-vc-tag 0..4094
no vlan-vc-tag [0..4094]
Context config>service>epipe>spoke-sdp
This command specifies an explicit dot1q value used when encapsulating to the SDP far end. When
Description
signaling is enabled between the near and far end, the configured dot1q tag can be overridden by a
received TLV specifying the dot1q value expected by the far end. This signaled value must be stored
as the remote signaled dot1q value for the binding. The provisioned local dot1q tag must be stored as
the administrative dot1q value for the binding.
When the dot1q tag is not defined, the default value of zero is stored as the administrative dot1q
value. Setting the value to zero is equivalent to not specifying the value.
The no form of this command disables the command
no vlan-vc-tag
Default
0..4094 — Specifies a valid VLAN identifier to bind an 802.1Q VLAN tag ID.
Parameters
7210 SAS M Services Guide
1 — 4
Values
16 — 1048575
Values
2048 — 18431
Values
Virtual Leased Line Services
Page 237