Alcatel-Lucent 7210 SAS M Service Manual page 806

Show, Clear, Debug Commands
Page 806
Label
Signal
Signaling
Last Status Change
Last Mgmt Change
Number of SDPs
Hello Time
Number of SDPs
Hello Time
Hello Msg Len
Hello Timeout
Unmatched Replies
Max Drop Count
Hold Down Time
TX Hello Msgs
Rx Hello Msgs
Associated LSP
List
Description (Continued)
Specifies the signaling protocol used to obtain the ingress and egress
labels used in frames transmitted and received on the SDP.
Specifies the time of the most recent operating status change to this
SDP.
Specifies the time of the most recent management-initiated change to
this SDP.
Specifies the total number of SDPs displayed according to the criteria
specified.
Specifies how often the SDP echo request messages are transmitted on
this SDP.
Specifies the total number of SDPs displayed according to the criteria
specified.
Specifies how often the SDP echo request messages are transmitted on
this SDP.
Specifies the length of the SDP echo request messages transmitted on
this SDP.
Specifies the number of seconds to wait for an SDP echo response
message before declaring a timeout.
Specifies the number of SDP unmatched message replies.
Specifies the maximum number of consecutive SDP echo request mes-
sages that can be unacknowledged before the keepalive protocol
reports a fault.
Specifies the amount of time to wait before the keepalive operating sta-
tus is eligible to enter the alive state.
Specifies the number of SDP echo request messages transmitted since
the keepalive was administratively enabled or the counter was cleared.
Specifies the number of SDP echo request messages received since the
keepalive was administratively enabled or the counter was cleared.
When the SDP type is MPLS, a list of LSPs used to reach the far-end
router displays. All the LSPs in the list must terminate at the IP address
specified in the far end field.
If the SDP type is GRE, then the following message displays:
SDP Delivery Mechanism is not MPLS
7210 SAS M Services Guide