Customers; Service Access Points (Saps); Figure 2: Service Access Point (Sap) For 7210 Sas-M In Network Mode - Alcatel-Lucent 7210 SAS M Service Manual

Customers

The terms customers and subscribers are used synonymously. The most basic required entity is the
customer ID value which is assigned when the customer account is created. To provision a service,
a customer ID must be associated with the service at the time of service creation.

Service Access Points (SAPs)

Each subscriber service type is configured with at least one service access point (SAP). A SAP
identifies the customer interface point for a service on an Alcatel-Lucent 7210 SAS M-Series
router
specified. The slot, MDA, and port parameters must be configured prior to provisioning a service
(see the
A SAP is a local entity to the router and is uniquely identified by:
•
•
•
Depending on the encapsulation, a physical port can have more than one SAP associated with it.
SAPs can only be created on ports designated as "access" in the physical port configuration.

Figure 2: Service Access Point (SAP) for 7210 SAS-M in Network Mode

7210 SAS M Services Guide
(Figure 3). The SAP configuration requires that slot, MDA, and port information be
Cards, MDAs, and Ports
The physical Ethernet port
The encapsulation type
The encapsulation identifier (ID)
SAP
Customer
3/1/6
27
dot1q
SAP
Customer
2/2/3
27
dot1q
sections of the 7210 SAS OS Interface Configuration Guide).
Cust-27
Service SDP
ALA-A
IP/MPLS Network
OSSG002
Services
Page 29