Alcatel-Lucent 7210 SAS M Service Manual page 672

VPRN Service Configuration Commands
limit — The number of routes that can be learned from a peer, expressed as a decimal integer.
Parameters
log-only — Enables the warning message to be sent at the specified threshold percentage, and also
percent — The threshold value (as a percentage) that triggers a warning message to be sent. The
rapid-withdrawal
Syntax [no] rapid-withdrawal
Context config>service>vprn>bgp
This command disables the delay (Minimum Route Advertisement) on sending BGP withdrawals.
Description
Normal route withdrawals may be delayed up to the mininum route advertisement to allow for
efficient packing of BGP updates.
The no form of the command removes this command from the configuration and returns withdrawal
processing to the normal behavior.
no rapid-withdrawal
Default
remove-private
Syntax [no] remove-private
Context config>service>vprn>bgp
config>service>vprn>bgp>group
config>service>vprn>bgp>group>neighbor
This command allows private AS numbers to be removed from the AS path before advertising them
Description
to BGP peers.
When the remove-private parameter is set at the global level, it applies to all peers regardless of
group or neighbor configuration. When the parameter is set at the group level, it applies to all peers in
the group regardless of the neighbor configuration.
The OS software recognizes the set of AS numbers that are defined by IANA as private. These are AS
numbers in the range 64512 through 65535, inclusive.
The no form of the command used at the global level reverts to default value. The no form of the
command used at the group level reverts to the value defined at the global level. The no form of the
command used at the neighbor level reverts to the value defined at the group level.
no remove-private — Private AS numbers will be included in the AS path attribute.
Default
Page 672
1 — 4294967295
Values
when the limit is exceeded. However, the BGP peering is not dropped.
default value is 90%.
7210 SAS M Services Guide