Figure 32: Sdps - Uni-Directional Tunnels - Alcatel-Lucent 7210 SAS M Service Manual

Configuring SDP Bindings
Note: SDPs are not supported by 7210 SAS-M devices configured in Access Uplink mode.
Figure 32
identifying the service and customer IDs, and the uni-directional SDPs required to communicate to
the far-end routers.
A spoke SDP is treated like the equivalent of a traditional bridge "port" where flooded traffic
received on the spoke SDP is replicated on all other "ports" (other spoke and mesh SDPs or SAPs)
and not transmitted on the port it was received.
ALA-1
EPIPE 2 FOR
CUSTOMER 6
Use the following CLI syntax to create a spoke SDP binding with an Epipe service:
CLI Syntax: config>service# epipe service-id [customer customer-id]
7210 SAS M Services Guide
displays an example of a distributed Epipe service configuration between two routers,
demux
SDP 2
Figure 32: SDPs — Uni-Directional Tunnels
spoke-sdp sdp-id:vc-id [vc-type {ether | vlan}]
vlan-vc-tag 0..4094
egress
filter {ip ip-filter-id}
vc-label egress-vc-label
ingress
filter {ip ip-filter-id}
vc-label ingress-vc-label
no shutdown
Virtual Leased Line Services
SPOKE-SDP 3
SPOKE-SDP 2
ALA-2
SDP 3
EPIPE 2 FOR
CUSTOMER 6
demux
Page 189