Alcatel-Lucent 7210 SAS M Service Manual page 662

VPRN Service Configuration Commands
ipv4 — Provisions IPv4 support.
Parameters
group
Syntax group name [dynamic-peer]
no group
Context config>service>vprn>bgp
This command creates a context to configure a BGP peer group.
Description
The no form of the command deletes the specified peer group and all configurations associated with
the peer group. The group must be shutdown before it can be deleted.
None — No peer groups are defined.
Default
name — The peer group name. Allowed values is a string up to 32 characters long composed of
Parameters
dynamic-peer — This flag designates that the given BGP group will be used by BGP peers created
neighbor
Syntax [no] neighbor ip-address
Context config>service>vprn>bgp>group
This command creates a BGP peer/neighbor instance within the context of the BGP group.
Description
This command can be issued repeatedly to create multiple peers and their associated configuration.
The no form of the command is used to remove the specified neighbor and the entire configuration
associated with the neighbor. The neighbor must be administratively shutdown before attempting to
delete it. If the neighbor is not shutdown, the command will not result in any action except a warning
message on the console indicating that neighbor is still administratively up.
none — No neighbors are defined.
Default
ip-address — The IP address of the BGP peer router in dotted decimal notation.
Parameters
Page 662
printable, 7-bit ASCII characters. If the string contains special characters (#, $, spaces, etc.), the
entire string must be enclosed within double quotes.
dynamically based on subscriber-hosts pointing to corresponding BGP peering policy. There can
be only one BGP group with this flag set in any given VPRN. No bBGP neighbous can be
manually configured in a BGP group with this flag set.
disabled
Default
ipv4-address :
Values
a.b.c.d
7210 SAS M Services Guide