Alcatel-Lucent 7210 SAS M Service Manual page 753

Context show>router
This command displays aggregated routes.
Description
active — This keyword filters out inactive aggregates.
Parameters
Show Aggregate Output Fields — The following table describes router aggregate output fields.
Output
Sample Output
*A:ALA-12# show router 3 aggregate
==============================================================================
Aggregates (Service: 3)
==============================================================================
Prefix
------------------------------------------------------------------------------
------------------------------------------------------------------------------
No. of Aggregates: 0
-----------------------------------------------------------
*A:ALA-12#
arp
Syntax arp [ip-address | ip-int-name | mac ieee-mac-addr]
Context show>router
This command displays the router ARP table sorted by IP address.
Description
If no command line options are specified, all ARP entries are displayed.
ip-addr — Only displays ARP entries associated with the specified IP address.
Parameters
ip-int-name — Only displays ARP entries associated with the specified IP interface name.
mac ieee-mac-addr — Only displays ARP entries associated with the specified MAC address.
7210-SAS M Services Guide
Label
Prefix
Summary
AS Set
Aggr AS
Aggr IP-Address
State
No. of Aggregates
Summary
Displays the destination address of the aggregate route in dotted
decimal notation.
Specifies whether the aggregate or more specific components are
advertised.
Displays an aggregate where the path advertised for the route con-
sists of all elements contained in all paths that are being summarized.
Displays the aggregator path attribute to the aggregate route.
The IP address of the aggregated route.
The operational state of the aggregated route.
The total number of aggregated routes.
AS Set Aggr AS
VPRN Show Commands
Description
Aggr IP-Address State
Page 753