Alcatel-Lucent 7210 SAS M Service Manual page 686

Show, Clear, Debug Commands
Ethernet Tunnel MEP Defect Legend:
R = Rdi, M = MacStatus, C = RemoteCCM, E = ErrorCCM, X = XconCCM
*A:NS1015C0821>show#
Show Ethernet Ring — The following table describes show command output fields.
Output
Description
Admin State
Oper State
Node ID
Guard Time
Max Revert time
CCM Hold down time
APS TX PDU
Defect Status
RPL Node
Time to revert
CCM Hold Up Time
Sub-Ring Type
Interconnect-ID
Compatible Ver-
sion
*A:NS1015C0821>show# eth-ring 10
===============================================================================
Ethernet Ring 10 Information
===============================================================================
Description
Admin State
Node ID
Guard Time
Max Revert Time
CCM Hold Down Time :
Compatible Version : 2
APS Tx PDU
Page 686
Label
The ring description
Displays the administrative state
Displays the operational state
Displays the node identifier
Displays the configured guard time
Displays the configured maximum revert time
Displays the configured CCM Hold down time
Displays the APS TX PDU information
Displays the defect status
Displays the RPL node information
Displays the configured time to revert
Displays the configured CCM Hold up time
Displays the sub-ring type information, the sub-ring type can be virtual
link or on-virtual link.
Displays the interconnect ID. The ID can be a ring-index ID or VPLS
service ID.
Displays the Ethernet ring version information.
: (Not Specified)
: Down
: 00:25:ba:03:48:04
: 5 deciseconds
: 300 seconds
0 centiseconds
: N/A
Description
Oper State : Down
RPL Node : rplNone
Time to Revert : N/A
CCM Hold Up Time :
7210 SAS M Services Guide
20 deciseconds